POP-UP irrigation systems
Without well done project, a system for watering certainly not properly working. Hence the green area which is the Gulf will quickly collapse and the damage increases over time chained. Our projects of irrigation systems are rational and watering systems made on the basis of their plants and lawns provide the optimal amount of moisture. Made them engineers with licenses and years of experience, not only in design but also in the works.
Without well done project, a system for watering certainly not properly working. Hence the green area which is the Gulf will quickly collapse and the damage increases over time chained. Our projects of irrigation systems are rational and watering systems made on the basis of their plants and lawns provide the optimal amount of moisture. Made them engineers with licenses and years of experience, not only in design but also in the works.
To do this scheme or project system for watering your garden, we need following data:
✓ The project of the garden in the scale or sketch with exact dimensions of the garden to be watered with marked existing and planned plants, facilities, trails, sinkholes, bit altitudes, fences, walls and other objects that may be barriers to watering.
✓ The exact pressure of the water supply network that will supply the irrigation system (for example, 3.5 bar). To measure the static pressure in the existing water supply network necessary pressure gauge.
✓ The flow in the inlet pipe from which it will supply the irrigation system. Data on the flow will get when the water source set larger container known volume (for example a bucket volume of 10 liters), open the valve or faucet all the way and at the same time you start to measure time with a stopwatch. When the container (bucket) is filled, stop the stopwatch and read off the time elapsed until the container (bucket) is not filled. Let’s say you have a bucket of water volume of 10 liters filled in 20 seconds. From this data we can easily obtain information on the flow of water in the port, which in this example is 30 liters per minute.
✓ Data on connection to the source of water that will be connected to the installation of irrigation systems. These data refer to the position, type and dimensions of the connecting pipes.
✓ The selection of appropriate sites for setting up the remote control unit – the controller. When choosing the place where it will be the controller should keep in mind that it is for his work usually required electricity, although some of whose work are enough batteries. There are controllers for outdoor installation and are to be installed only indoors. In addition, it should be known, and that he is usually in a conduit with electromagnetic valves which are located at the beginning of the feed pipeline individual zone irrigation system. Solenoid valves are usually placed in special plastic shaft made for that purpose.
The accuracy of these data is very important for the development of the whole project system for watering, especially in precision hydraulic calculation of whose accuracy depends on the quality work designed irrigation system.
See also:
Installation of irrigation systems
Maintenance of irrigation systems
Design yourself irrigation system
